NikLyn Corporation

Your high quality finish begins with the substrate preparation.  We take that seriously and offer a full spectrum of surface prep from abrasive blast cleaning, Iron Phosphate 3, 5 & 7 stage process and Zinc Phosphate to a full line of conversion coatings.

Our North Eastern US Facility has over 120,000 square feet available to handle all size projects simultaneously. 

Hubzone certified and WMBE. / Disabled Veteran Owned

Here we have multiple automated lines for both powder coating and wet spray. 

Large batch capcity able to fit a tractor trailer into one of our ovens.  

5,000 square foot abrasive blasting room and a Large Lay-down area. 

Sandblasting or abrasive blasting is used for many reasons but most importantly, its used as a method of removing scale from steel. In any coating process the condition of your base is your weakest link.  The best systems can fail if the substrate is not properly prepared. 

Leaving rust on a substrate will only allow it to continue to form under your coating and at some point your coating will bubble up and pop as the oxidation pushes up on it.  This spot failure will open the protective coating up to the elements and the rest of the surface will quickly begin to fail as moisture creeps in from the breaks.

This is why we always pre blast steel substrates when possible